Select the type of profile handle and the side of the handle from the drop-down list.

The front cover of the facade in the picture is facing the viewer.

Minimum handle size restrictions:
Profile handle 00,18,38

The minimum size of a facade with Schuco handles is 150×110 mm.

That is:
• if the height of the facade is ≥ 150 mm, then the width is ≥ 110 mm;
• if the width of the facade is ≥ 150 mm, then the height is ≥ 110 mm.

Select the edge side of the facade from the list. When selecting, take into account the selected side of the handle profile.

Select the edge decor - by default, we select an edge decor similar to the facade decor.

If you want to choose a different edge decor, write the edge decor code in the “Comment” field.

Select the side of standard openings for hinges:

Please note that the side of the openings is shown from the front side of the facades!

The possible number of openings for hinges on the facade is from 2 to 5, depending on the size of the selected side of the facade. The indentation from the edge in height will be 100 mm, in width - 22 mm, counting this distance from the center of the hole.

Check if the holes are selected on the smaller side of the facade?

Standard hinge holes Standard hinge holes are determined automatically:

Length - horizontal side of the part, along the direction of the panel decoration.

For Acryl, CrystaLine, and SmartLine collections, the length of the part is limited to between 120 and 2780 mm.

For HPL collections, the length of the part is limited to between 120 and 4180 mm.

Width is the vertical side of the part. The width of the part is limited to between 50 and 1280 mm.

* Splicing - joining two parts of the same size on PUR glue along the plane, with subsequent formation of one part of double thickness.
If you need to perform 1 splicing from the selected material, select the number of parts 1.
If there is a desire to choose a non-standard edging, specify it in the note.